65% polyester/35% cotton
Twill.Do not soak.Wash separately.The product will retain its qualities for a maximum of 75 domestic washes or a maximum of 50 industrial washes.The dirt-repellent Teflon® finish is reactivated by tumble drying according to the washing instructions.
Industrial washing process for safety workwear and two-tone workwear.
Yes - if handled according to these care instructions.
Wash according to ISO 15797 - 8A or 8B covering industrial wash. Wash separately.
Refer to info on reflective garments below.
pH: Max pH 10, max alkalinity 650 mg/l. Do not use: Alkali boosters, optical brighteners, bleaching agents, detergents that contain free sodium or potassium hydroxide, solvenated surfectants. Avoid use of softeners. Max 20 min. in main wash bath.
Clarify between local legislation and chemical supplier.
Tumble dry (ISO 15797 8A): Max outlet / exhaust temp 90ºC, use cool down. And / or Tunnel dry: (ISO 15797 8B) Max incoming air temp 155/160ºC. Cycle time: balanced to meet residual moisture content of +3%.
Close any zippers before washing.
Fluorescent and with reflective tapes. Two-toned. Teflon® makes the product dirt resistant. Triple stitched seams at leg and crotch. Ergonomically formed trouser leg. Adjustable straps in short, strong elastic with plastic buckles. Braces can be stored away behind the bib using small straps. Large bib pocket with pen opening,phone pocket with zip and flap with hidden press studs. Adjustable waist. Belt loops. Fly with zip. D-ring. Front pockets. Back pockets with reinforcement, flap and hidden press studs. Adjustable hammer loop. Reinforced thigh pocket with additional pockets; an inner phone pocket as well as an external phone pocket with flap and magnetic closure. Ruler pocket with CORDURA® reinforced opening. Kneepad pockets in durable CORDURA® (500 D) with flap and top access. Vertical reflexes on the side of the legs for better safety. Each standard leg length can be lengthened by 3 cm by releasing the internal red stitches.
The product is certified with maximum 0,2100m² logo area. This approved area must not be exceeded. Logo on, respectively, front or back of the product can constitute only a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification.
No liability accepted for product alterations.